[KARAOKE] [DJ GEAR] [GUITARS] [LIGHTING] [LIGHT BULBS] [NEW GEAR] [USED GEAR] [RENTALS] [BLOWOUTS!]
Crate V3112 Amplifier
Crate V3112 Amplifier at the lowest prices! Power Alley is an authorized dealer for Crate V3112 Amplifier! Free shipping on Crate V3112 Amplifier. Call 800-788-9552 for the best deal on Crate V3112 Amplifier!
5 YEAR Transferable warranty!
The V3112 is an enhanced single channel amp that operates in Class A configuration, and generates 30 watts RMS through a single 12" Celestion speaker. The Class A circuit essentially runs the Groove Tubes(TM) EL84's at full output at all times. For the tone and feel fanatic, this provides instant response, dramatic wolf tones and harmonics which are the hallmark of these classic circuit designs. The V3112 has internal spring reverb unit to produce a huge, wet sound, and quite possibly may be the best sounding 30 watt class A tube amp in the market. Players around the world are flocking to the v-series for something a little different. Check it out!
| 1. Input: Connect your
instrument here by means of a shielded signal cable. 2. Clean Volume: Use this control to adjust the output level of the Clean Channel. 3. Clean/Overdrive: This switch, when depressed, selects the Overdrive Channel. When this switch is in the out position, the Clean Channel is selected. 4. Overdrive Gain: Use this control to adjust the gain of the Overdrive Channel. With the control towards the counter clockwise position, the gain is low and very little distortion is present. As you rotate the control clockwise the gain increases, producing more overdrive distortion and a higher output volume level. 5. Treble: Use this control to adjust the output level of the high frequencies. This control provides 12dB of cut or boost at 6kHz. 6. Boost: This switch, when depressed, increases the output by 10dB at 900Hz, giving the middle frequencies more punch 7. Mid: Use this control to adjust the output level of the middle frequencies. This control provides 10dB of cut or boost at 1kHz. 8. Bass: Use this control to adjust the output level of the low frequencies. This control provides 8dB of cut or boost at 150Hz. 9. Presence: This switch, when depressed, increases the output level of the high frequencies by 8dB at 10kHz, giving a more “glassy” sound to the amplifier. This helps the output of the amplifier cut through “acoustically dead” rooms. 10. Overdrive Level: Use this control to adjust the output level of the Overdrive Channel. 11. Reverb: Use this control to adjust the amount of reverberation applied to the signal. With the control fully counter clockwise no reverb is applied. As you rotate the control clockwise the amount of reverb increases. 12. Lamp: This lamp illuminates when the amplifier is turned on. 13. On/Standby: Use this switch to activate the amplifier. The On/Off switch (#14) should be turned on first. Allow 20 seconds for the amplifier to warm up before turning the Standby switch on. 14. On/Off: Use this switch to turn the amplifier on and off. This switch should be turned on at least 20 seconds before turning the Standby switch (#13) on. |