[KARAOKE] [DJ GEAR] [GUITARS] [LIGHTING] [LIGHT BULBS] [NEW GEAR] [USED GEAR] [RENTALS] [BLOWOUTS!]
Crate V58 Amplifier
Crate V58 Amplifier at the lowest prices! Power Alley is an authorized dealer for Crate V58 Amplifier! Free shipping on Crate V58 Amplifier. Call 800-788-9552 for the best deal on Crate V58 Amplifier!
5 YEAR Transferable warranty!
The V58 is an enhanced single channel amp that operates in Class A configuration, and generates 5, watts RMS through an 8" Celestion speaker. The Class A circuit essentially runs the Groove Tubes(TM) EL84's at full output at all times. For the tone and feel fanatic, this provides instant response, dramatic wolf tones and harmonics which are the hallmark of these classic circuit designs.
| 1. INPUT: Connect your
instrument here by means of a shielded signal cable. 2. GAIN: Use this control to adjust the input gain. With the control towards the counter clockwise position, the gain is low and very little distortion is produced. As you rotate the control clockwise the gain increases, producing more overdrive distortion and a higher output volume level. 3. TONE: Use this control to “dial in” the desired sound. Rotating the control counter clockwise enhances the midrange frequencies, while rotating it clockwise enhances more of the low and high frequencies simultaneously, with a myriad of tonal variations in between. 4. VOLUME: Use this control to adjust the output level of the amplifier. Use this control along with the Gain control (#2) to obtain the level you need. The Volume control also governs the level of the signal at the Line Out jack (#5). 5. LINE OUT: This jack provides a line level signal for connecting to a house mixing board, recording console or external amplifier. This jack can also double as in Insert jack, allowing you to add an external effect, as shown on the facing page. The jack is a stereo 1/4” type: tip = signal out, ring = signal in, sleeve = ground. 6. POWER LIGHT: This jeweled lens illuminates when the amplifier is turned on. 7. POWER SWITCH: Use this heavy duty switch to turn the amp on and off. (NOTE: Allow a few seconds once the amp is turned on to let the tubes warm up before playing.) The Rear Panel (not shown): AC LINE CORD: The grounded power cord should only be plugged into a grounded power outlet that meets all applicable electrical codes and is compatible with the voltage, power, and frequency requirements stated on the rear panel. Do not attempt to defeat the safety ground connection. |