CROWN XLS 202,FREE Shipping, Lowest Prices, 800-788-9552

Crown XLS 202 Amplifier

CROWN MICRO-TECH 2400 Amplifier at the lowest prices! Power Alley is an authorized dealer for the CROWN MICRO-TECH 2400 Amplifier! Free shipping on the CROWN MICRO-TECH 2400 Amplifier. Call 800-788-9552 for the best deal on the CROWN MICRO-TECH 2400 Amplifier!

250W @ 2 ohms

200W @ 4 ohms

145W @ 8 ohms

In Stereo Mode

500W in bridged Mode

Specifications
The following applies to units in Stereo mode with 8-ohm loads and rated input sensitivity unless otherwise specified.

Performance
Sensitivity (volts RMS) for full rated power at 4 ohms,
XLS-202: 0.725
XLS-402: 1.025
XLS-602: 1.26.
Frequency Response (at 1 watt) 20 Hz to 20 kHz: ±0.75 dB.
Phase Response (degrees at 1 watt)
at 10 Hz: –10.
at 20 kHz: +19.
Signal-to-Noise Ratio (20 Hz to 20 kHz)
A-weighted, below rated power: > 100 dB.
No weighting, below rated power: > 95 dB.
Total Harmonic Distortion (THD) at full bandwidth power, from 20 Hz to 1 kHz: < 0.5%.
Intermodulation Distortion (IMD) (60 Hz and 7 kHz at 4:1) from full rated output to –40 dB:
< 0.3%.
Damping Factor (8 ohm) 10 Hz to 400 Hz: >200.
Crosstalk (below rated power)
at 1 kHz: –82 dB.
at 20 kHz: –58 dB.
Voltage Gain (at maximum output): 31 dB.

Power
Load Impedance: Safe with all types of loads. Rated for 2 to 8 ohms in Stereo, 8 ohms in Bridge-Mono.
AC Line Voltages Available (±10%): 120VAC, 60 Hz and 230VAC, 50 Hz.

Controls
Level: Two front-panel, black rotary level controls, one for each channel.
Power: Front-panel switch; on when in the UP position.
Circuit Breaker: Provides overload protection.

Indicators
Clip: Two front-panel red LEDs, one for each channel, illuminate when the channel’s output signal is being overdriven.
Power: Green front-panel LED indicates amplifier has been turned on and AC power is available.
Fault: Yellow front-panel LED illuminates when amplifier is in protect mode. Also illuminates briefly during normal power-up when amplifier is first switched on.

Input/Output
Input Connectors: One per channel; back-panel three-pin female XLR input connectors.
Input Impedance: (nominally balanced, nominally unbalanced): 20 k ohms, 10 k ohms.
Output Connectors: Two 4-pole Speakon^® connectors (one per channel) and two pairs of 5-way binding posts; accepts banana plugs, spade lugs or bare wire. (European models do not accept banana plugs.)
DC Output Offset (shorted input): ±10 millivolts.
Output Signal: Stereo, unbalanced, two-channel.

Protection
XLS Series amplifiers provide extensive protection, including output current limiting, DC protection, circuit breaker, and special thermal protection for the unit’s transformers.

Construction
Ventilation: Flow-through ventilation from front to back.
Cooling: Internal heat sinks with forced-air cooling for rapid, uniform heat dissipation.
Air Volume Requirements (per minute per unit): 80.15 ft³ (2.27 m³).
Dimensions: EIA Standard 19-inch (48.3-cm) rack mount width (EIA RS-310-B), 3.5-inch (8.9-cm) height and 14-inch (35.6-cm) depth behind the mounting surface.

Weight
Net Weight,
XLS-202: 21.0 lbs. (9.5 kg);
XLS-402: 25.3 lbs. (11.5 kg);
XLS-602: 27.2 lbs. (12.3 kg).
Shipping Weight,
XLS-202: 26.0 lbs. (11.8 kg);
XLS-402: 30.3 lbs. (13.8 kg);
XLS-602: 32.2 lbs. (14.6 kg).